AT

x,y,z specify the center of the diamond. If z is specified then they are assumed to be data units.

FROM-TO

You may specify the diagonally opposite corners of box enclosing the diamond.

FILL

Fills in the diamond using the current fill pattern. See:SET FILL

CURSOR

The cross hair cursor is used to specify the limits of the diamond. Simply move the cross hairs so they define the lower-left limits of the diamond and press the space bar. Next move the cursor to the upper-right limits of the diamond an press space again. If you press a key other than space, the cursor information is not used. Alternately you may specify the upper-left then lower-right extension, or any other combination that defines the diamond.

DATA

Specifies X,Y are in data coordinate frame. Normally they are in the TEXT coordinate frame. This option is not necessary if z or DSIZE are specified.

DSIZE

DSIZE=dx[,dy] Specifies the size in data units. If the size is in data units the x,y are assumed to be data units also. DY is the height. If omitted DY=DX.

ROTATE

Specifies a rotation angle in degrees. Rotation is right handed or counterclockwise.

SIZE

SIZE=dx[,dy] specifies the size in inches DX is the width. If omitted the width is the default See:Command SET DIAMOND SIZE. DY is the height. If omitted DY=DX.

SOLID...

Sets the texture of the line. See:Command SET TEXTURE.

INTENSITY

Sets the intensity (1-5)

WHITE...

Sets the color of the line.